top of page

10/30/26, 6:43 PM

Trucking Analytics That Show What Every Truck Earns

Trucking Analytics That Show What Every Truck Earns

Most fleets can tell you how many miles they ran last week. Fewer can tell you what each truck earned after fuel, driver pay, maintenance, and empty miles came out. Trucking analytics answers that second question, truck by truck, from data you're already collecting.


Key takeaways

  • Trucking analytics should show what each truck, driver, and lane earned, not only how far they drove.

  • Telematics knows miles and fuel, and market data knows rates. The system holding your loads is where revenue meets cost.

  • Datatruck, a TMS for carriers, reports profit per truck, per driver, and per lane from the loads you dispatch.


What trucking analytics should answer


Each question below takes the financial metrics every trucking company should track and breaks them down to a single unit:


  • Revenue per truck: linehaul, fuel surcharge, and accessorials billed on that truck's loads.

  • Cost per truck: fuel, driver pay, tolls, maintenance, insurance, and the truck payment.

  • Profit per driver: what a driver's loads earned after their pay.

  • Profit per lane: revenue, cost, and rate per mile on each origin and destination pair.

  • Deadhead: empty miles per truck, and what they cost you.

  • Fuel and maintenance: spend per truck per mile, so one aging tractor stands out.


Per-truck profit is the anchor. Here's why profit per truck is the KPI most fleets skip.


Why trucking analytics needs per-truck numbers


ATRI's 2026 Operational Costs of Trucking report put the average cost to run a truck at $2.336 a mile in 2025, the highest in the report's history. Repair and maintenance rose 8.6 percent, and tolls rose 13.2 percent. Truckload and refrigerated carriers still averaged operating margins under 1 percent.


At that margin, two or three trucks running below cost can erase what the rest of the fleet made. A fleet average won't tell you which trucks they are. You'll need your own cost per mile, by truck, set against what each truck billed.


Where fleet analytics data comes from


Most fleet analytics tools see one side of the ledger. Here's what each source can't tell you alone.


Source

What it knows

What it can't tell you

ELD and telematics

Miles, location, idle time, engine faults

What the load paid

Freight market data

Spot and contract rates by lane

Your costs on that lane

Fuel cards

Gallons and dollars by truck

Which load the fuel was for

Maintenance records

Repairs and parts by unit

What that unit earned

Accounting software

Fleet-wide profit and loss

Profit by truck, driver, or lane

TMS

Loads, rates, trucks, drivers, settlements

Costs it never receives from the sources above


Telematics is the source most fleets start with, and it's worth knowing what fleet telematics records. The join happens where your loads live, since that's where revenue first gets tied to a truck and a driver.


Trucking analytics vs a dashboard of miles


A miles dashboard shows activity: miles run, hours driven, trucks moving. It's useful for dispatch. It won't tell you whether Truck 114 made money last week.


Analytics starts from the load. Each load carries a rate, a truck, a driver, and a lane, and costs attach to it. Then you can set loaded miles against the deadhead miles on each truck and see what the empty ones cost.


Out of the top metrics for a trucking company, pick the few that change a decision you make each week.


Quick math: one truck, one week (example)

  • Truck 114 billed $7,200 on 2,600 miles, 400 of them empty.

  • At ATRI's 2025 average of $2.336 a mile, those miles cost about $6,074.

  • That leaves roughly $1,126, or $0.43 a mile. Use your own cost per mile for the real figure.


The weekly trucking analytics reports worth reading


You don't need twenty reports. These five lead to a decision while there's still time in the week to act on it:


  1. Weekly gross board: revenue by truck and dispatcher this week.

  2. Weekly net profit report: what each truck kept after its costs.

  3. Load report with charge and expense breakdown: where one load's money went.

  4. Invoice aging: billed loads that haven't been paid yet.

  5. Maintenance report: repair spend by unit.


Compare them with the six reports fleet owners review weekly to set your own routine.


Truck fleet analytics by lane, driver, and dispatcher


A truck can lose money because of the lane it runs, not the driver in it. Lane analytics shows revenue, cost, rate per mile, and mileage on each lane, so you can see which ones pay before you book them again. Here's how carriers find unprofitable lanes in their network.


Driver and dispatcher views answer different questions. Pava kept dispatchers it was about to let go once it could see their numbers. If you run owner-operators or leased trucks, leave them out of the margin math, so their gross doesn't inflate what your company trucks earn.


Trucking analytics inside Datatruck


Datatruck reports profit per truck, per driver, and per lane from the loads you already dispatch. Load reports break each load into charges and expenses, and net profit is tracked per truck. Embedded Power BI dashboards sit on that data, and Pava runs its 200 trucks with real-time cost per mile.


When a report doesn't cover your question, BI Agent, Datatruck's AI-native analytics assistant, answers it in plain English, such as which trucks lost money this month. An oversized-freight carrier's ops lead said: "It came down to the reporting. Datatruck answered every need we had." See what Datatruck's analytics dashboards show.




FAQs


What is trucking analytics?


Trucking analytics ties revenue and costs to each truck, driver, load, and lane so you can see what each one earns. It goes past telematics, which records miles and engine data but not what a load paid.


What's the difference between fleet analytics and trucking analytics?


Fleet analytics usually means vehicle data: location, fuel use, idle time, and maintenance. Trucking analytics for a carrier adds the revenue side, so those costs sit next to what each truck billed.


Which trucking analytics metrics matter most?


Profit per truck matters most, followed by cost per mile, revenue per mile, deadhead percentage, and profit per lane. Read them weekly by truck, not as fleet averages.


Do I need separate analytics software if I have a TMS?


You don't, as long as your TMS reports profit by truck, driver, and lane. If it only stores loads, you'll end up exporting to spreadsheets or a BI tool to join revenue with fuel, maintenance, and pay.


Previous
Next
bottom of page